Comparison between CONDOR XC-007, Italian made machine and cloned equipment

As a locksmith tools dealer, I often was asked about which key Cutting Machine is good, for there are so many machines expensive one is not the best and cheap one also can be an option. It is hard to answer. Therefore, here I am concluding comparison between CONDOR XC-007, Italian made machine and cloned equipment; in this way, you may get what you want.

Structure

Condor xc-007 is applied with the same machine structure with Italian made machine, whole Aluminum structure, Aluminum alloy casting, but clones with steel structure, easy to out of shape.

Spindle motor

Xc-007 and Italian made are with force, but the clones with small force, xc-007 with brushless motor, and clones with Carbon flash electricity.

Fixture

The fixture of xc007 can change, and so as to the Italians, but some part of clone cannot change and either no support update to support more fixtures.

Display

Almost the same size of display screen, made by XC007 made by Chinese but support English, while Italian made with Chinese; part of clones with the same size, some smaller.

Requirement on cutter

No specific requirement on xc007, specific cutter for Italian made ones, can be compatible with most of the cutters.

Key data base

The former two support key data base and update online, while the last one without key data base.

After sale service

Xc007 support after sale service and remote control technique support, Italian made ones supported by original plants

Carry

The former two are not easy to be carried, while clones could.

Cutting time

Both former ones are quick in cutting, once cutting to milling key, but the later one is cutting slowly, and need to be cut several times for their small motor.

Prices

CONDOR XC-007 is cost-effective, about $2900, while Italian made is more expensive, and clones very cheap.

That is the conclusion on these three types, may be you could have a consideration on them. If you have interest in condor xc-007, please link here.